KRYOTEC ENGINE 152 23. Fit the bearing caps complete with bearing shells (1). 24. Tighten the bearing cap bolts (1a) using a suitable angle tightening tool (1b) to the proper (Torque Specifications). 25. Remove the bearing caps previously installed and using the graduated measuring guide (1a) determine the bearing clearance indicated by the calibrated wire (1b). NOTE If the measured value is not within specification, replace the bearing shells with the proper dimension of the appropriate class. Perform the measurement on the remaining journals taking care not to rotate the crankshaft. 26. Check that the diameter of the connecting rod small end bushings are within specification (Refer to 09 - Engine/ Specifications). 27. Verify that the internal diameter of the pistons pin bores are within specification (Refer to 09 - Engine/ Specifications). 28. Make sure that the outer diameter of the piston pins are within specification (Refer to 09 - Engine/ Specifications). 29. Insert the piston rings in the cylinder bore and check that the end gaps are within specification (Refer to 09 - Engine/Specifications). 30. Make sure that the piston outer diameter is within specification (Refer to 09 - Engine/Specifications). NOTE Measure 7 mm up from the bottom edge of the piston skirt, perpendicular to the piston pin bore. 31. Check that the piston to cylinder bore clearances are within specification (Refer to 09 - Engine/Specifications). 32. Check that the thickness of the piston rings are within specification (Refer to 09 - Engine/Specifications).
RkJQdWJsaXNoZXIy MTIwNTUz