KRYOTEC ENGINE 145 to engine block stud and tighten to the proper torque specification (Torque Specifications). 7. Install the starter (1a) with a new gasket and tighten the bolts (1b) to the proper torque specification (Torque Specifications). 8. Connect the ground cable to the starter and tighten the nut to the proper torque specification (Torque Specifications). 9. Connect the battery positive cable to the starter and tighten the nut to the proper torque specification (Torque Specifications). 10. Install the DPF mounting bracket and tighten the bolts to the proper torque specification (Torque Specifications). 11. Install the DPF to the mounting bracket with a new gasket and tighten the nuts to the proper torque specification (Torque Specifications). 12. Install the DPF to turbocharger clamp (1) and tighten the nut to the proper torque specification (Torque Specifications). 13. Install the turbocharger heat shield and tighten the bolts to the proper torque specification (Torque Specifications). 14. Connect the exhaust gas hose and tighten the clamp to the proper torque specification (Torque Specifications). 15. Install the pressure sensor tube and tighten the fittings to the proper torque specification (Torque Specifications). 16. Connect the DPF temperature sensor wire harness connector. 17. Connect the upstream oxygen sensor wire harness connector. 18. Connect the exhaust gas temperature sensor wire harness connector. 19. Install a new O-ring seal to the PTU. 20. Install the PTU (1a) to the transmission with the bolts (1b) tightened to the proper torque specification (Torque Specifications). 21. Connect the power transfer unit actuator wire harness connector (1).
RkJQdWJsaXNoZXIy MTIwNTUz