KRYOTEC ENGINE 92 14. Remove the hydraulic lifters complete with rockers (1). 15. Remove the bolts (1a) and the cylinder head complete (1b) 16. Remove and discard the cylinder head gasket (1). 17. If it is necessary to disassemble any of the remaining components, refer to (Refer to 09 - Engine/Cylinder Head/ Disassembly and Assembly). 18. Clean the bottom of the cylinder head from old gasket residue. NOTE If the flatness of the bottom of the cylinder head does not fall within the required limit, correct not to exceed the minimum height allowed. 19. Check that the flatness of the bottom of the cylinder head is within the prescribed limit. FITMENT NOTE The centering bushes between the crankcase and cylinder head are shorter (12.5 mm) compared to those between the cylinder head and cylinder head cover; so be careful not to reverse them as it may impair the efficiency of the engine. 1. Install the cylinder head centering bushing into the engine block, gearbox side.
RkJQdWJsaXNoZXIy MTIwNTUz