AMT KIT 18 B. MECHATRONIC GEAR ACTUATOR UNIT (MGA) REMOVAL AND RE-FITMENT: REMOVAL: then remove hydraulic system and drain oil in to canister. Remove Oil tank (Refer oil tank removal procedure). Unscrew and remove the three screws fixing pulling its body by hand in vertical direction; pay attention that a small quantity of oil will flow out from the tank port. -rings and the flat gasket. In the pictures below is an example of dismounting, where the gasket and one OGear the other parts remain INSTALLATION: NOTE: Verify that the gearbox is in neutral gear position, because is provided in this position; otherwise rotate the gearbox command lever by hand to achieve the position corresponding to the Mechatronic Gear Actuator before mounting. to avoid O-rings damages, screw three rods screws and shown in the picture below. he
RkJQdWJsaXNoZXIy MTIwNTUz