TIAGO AMT Gasoline DTC Troubleshooting Guide Version: 2.0 Date: 06-06-2016 Author: Sathi/Anupama Page: 423 of 424 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. -TCU damage 126 P060C07 Level 3 Intervention System problem -Wiring harness problem -Hardware damage -Wrong execution conditions -TCU damage 127 P1844 - 07 Grid Self tuning Procedure Error -Wiring harness problem -Wrong execution conditions -Wiring Harness Connections - TCU 128 P080A - 07 Kiss point Self tuning Procedure Error -Wiring harness problem -Wrong execution conditions -Wiring Harness Connections - TCU 129 P185B - 07 Clutch Stroke Self tuning Error -Wiring harness problem -Clutch assembly 130 P188607 -Dual Port RAM Check -Hardware damage - TCU damage 131 U000101 -CAN EMS Error - Wiring harness problem -Electromagnetic interference -High frequency noise. 132 C008200 ABS Status CAN signal Invalid -ABS Unit Problem -Check ABS Service Manual 133 U000188 Vehicle Communication Bus - Bus off - Wiring harness problem CAN_H and CAN_L wires 134 U012108 Lost communication with Antilock Braking System- ABS Bus signal/ Message Failure -At least a message of ABS node is missing. -Disconnection of the ABS connector -CAN_H and CAN_L lines open at TCM connector end 135 U015508 Lost communication with Instrument Panel Cluster Module- Bus signal/ Message Failure -At least a message of IPC node is missing. -Disconnection of the IPC connector -CAN_H and CAN_L lines open at TCM connector end 136 U010008 Loss of communication with Engine Control Module- Bus Signal/ Message Failure -At least a message of EMS node is missing. -Disconnection of the IPC connector -CAN_H and CAN_L lines open at TCM connector end 137 P1C1001 Invalid Data Received From ECM-Cyclic Redundancy Check Error -EMS (106 frame)Checksum different from that one received -Electromagnetic interference - High frequency noise 138 P1C1102 Invalid Data Received From ECM -Message Rolling Counter Error -EMS (106 frame) rolling counter does not change in two consecutive frames. -Electromagnetic interference - High frequency noise. 139 P1C1201 Invalid Data Received From ECM-Cyclic Redundancy Check Error -EMS(108 frame)Checksum different from that one received -Electromagnetic interference - High frequency noise.
RkJQdWJsaXNoZXIy MTIwNTUz