AMT KIT 25 t. slot, continue the translation of the ball with care. Preassemble the two screws M5x15 in the motor flange at 180° before and after the third screw M5x15 (the ground screw) without tighten. Then screw with alternating sequence the two screws at 180° until to reach the right torque (6 ± 1 [Nm]) and then tighten the ground screw with the same torque. Connect the connector of the wiring harness Tank Removal and Re-Fitment on Bench). E. HYDRAULIC OIL ACCUMLATOR REMOVAL AND RE-FITMENT: DANGER!! Do not remove hydraulic oil accumulator, it is pressurized unit it can pose a safety threat. F. CLUTCH POSITION SENSOR REMOVAL AND RE-FITMENT: Removal: Disconnect the connector of the wiring Unscrew and remove the two screws fixing Unit Installation: seat using the two screws at the right torque 2.5 ± 0.1 Nm. Connect the connector of the wiring harness
RkJQdWJsaXNoZXIy MTIwNTUz