BRAKE 24 13. BRAKE PEDAL ASSEMBLY REMOVAL 1. Disconnect Electrical connection on regenerative brake pedal sensor. 2. Remove split pin to disconnect pedal from brake booster. 3. Remove clevis pin to separate booster assembly from pedal. 4. Loosen and remove the brake mounting M8 nuts from panel firewall RHD. INSTALLATION 1. Hold the brake control bracket on firewall. 2. Tighten the brake upper mounting M8 nut. 3. Tighten the brake mounting M8 nuts on panel firewall RHD. 4. Match clevis hole to the pedal lever hole and insert clevis pin into the hole. 5. Insert split pin in to the hole of clevis pin and split the end of split pin. NOTE: 1. Not to add carpet over the basic carpet in the pedal region. 2. Basic carpet should be held firmly in the pedal region.
RkJQdWJsaXNoZXIy MTIwNTUz