STEERING_MANDO 22 14. While removing don’t hit on cross car beam. 15. Don’t keep the part directly on floor. 16. Don’t use hammer or rod to remove EPAS I/Shaft. NOTE Bellow is a seal. Do not use sharp tools near bellows if it can damage bellows. CAUTION Damaged bellow or absence of clip can cause water ingress and subsequent failure of Power steering. DO’S 1. Lift steering gear by holding mountings / body / cylinder only. 2. Store / transport steering gear resting on body / cylinder only. 3. Use steering gears on ‘first in first out’ basis. 4. If any steering gear is dropped, inspect for damage before using. 5. If any bellow is found damaged, replace it immediately with a good part & with proper position of clips 6. If any bellow clip is found missing, do not use the defective steering gear. Instead use another new steering gear 7. If the steering gear is off the vehicle, all ports should be covered with protective plugs to avoid contamination. 8. If any bellow is found damaged, replace it immediately with a good part & with proper position of clips. 9. If any bellow clip is found missing, do not use the defective steering gear. Instead use another new steering gear. 10.If the steering gear is off the vehicle, all ports should be covered with protective plugs to avoid contamination. 11.Do use steering puller to avoid capsule collapse & column serration damage. Image for illustration purpose only
RkJQdWJsaXNoZXIy MTIwNTUz