ELECTRICAL 31 even if the actual INST FE is higher than 30 km/l. For MPG setting, the indicated maximum value of INST FE is 80 MPG. No more than 80 shall be indicated on the display even if the actual INST FE is higher than 80 MPG. 6 DEF Gauge When the ignition switch is in “ON” position, DEF gauge gives an approximate indication of the amount of DEF in the fuel tank. “F” stands for full and “E” stands for empty. When DEF in the tank is near to empty position, low DEF level warning Telltale turns on in Amber. Refill the tank as soon as possible. 7 TPMS TPMS (Tire Pressure Monitoring System) shows the pressure/temperature of respective tire. When tire temperature of any tire will be high then the “HI” indication for respective tire instead of temperature value will be displayed for 4 sec. Rest all tires will have respective temperature value along with unit for 4 sec then the pressure for respective tire will be displayed. Similarly, When tire pressure of any tire will be high/low then the “HI”/”LO” indication for respective tire instead of pressure value will be displayed for 4 sec. “AL” will be displayed for respective tire having Air Leakage. “--” will be displayed for respective tire having sensor missing or malfunction fault. For any of the above warning respective tire on display will be in blinking state. NOTE: If any of the warning is displayed, it means ‘Fault’ condition. In such case, take vehicle to air station to maintain the desired pressure level. 8 Clock Indicates current time in AM/PM mode. Clock time can be changed using ‘SET’ & ‘MODE’ knob. 12/24 hr format can be changed using MODE button. Whenever the battery terminals or related fuses are connected, you must reset the clock time. This feature is available when ignition switch is in ON’ position. NOTE: Clock settings can also be changed through infotainment system 9 Outside Ambient Temperature Displays outside ambient temperature in units °C or °F. Resolution: 1 °C or °F Note: User can change the Temperature unit using SET and MODE buttons and °F is applicable for Export variant only. The temperature sensor is in the front bumper of the vehicle, therefore the temperature reading can be affected by heat reflection from the road surface, engine heat and the exhaust from surrounding traffic. This can cause an incorrect temperature reading when speed is under low speeds or when stopped. If display shows ‘- - ‘, take your car to TATA authorized service Centre. 10 Service reminder Indicates the number of days or kilometers remaining for next service at every ignition ON for few seconds if service is due. If service is overdue, DIS will display 0 km or 0 days and spanner symbol will blink at every ignition ON for few seconds. DIS will indicate Spanner symbol as continuously ON when
RkJQdWJsaXNoZXIy MTIwNTUz