BODY 48 1.4.36 PLENUM COVER: REMOVAL 1. Open the Bonnet. 2. Disconnect the negative terminal of battery. 3. Remove both front wiper arm and blade assembly. (Refer wiper arm and blade assembly removal process). 4. Pay out seven Grommet pin and pull out plenum cover , FITMENT For fitment follow reverse procedure of removal. 1.4.37 GEAR LEVER BOOT REMOVAL 1. Pull out the rubber knob from GEAR SHIFT UNIT 2. Remove the Lather boot from the gear shifter lever. FITMENT For fitment follow reverse procedure of removal. 1.4.38 BONNET INSULATION REMOVAL 1. Open the bonnet. 2. Pull out the insulation from the bonnet assembly. FITMENT For fitment follow reverse procedure of removal. NOTE While pulling out the Bonnet insulation, care should be taken such that clips do not get damage if found damaged replace the same with the new one 1.4.39 GLASS FIXING OF WIND SCREEN GLASS & TAIL GATE GLASS The glasses are directly pasted to sheet metal flanges using sealant. We give below the Equipment / materials required and the procedure for fixing the Wind screen and Backlight glasses. EQUIPMENTS REQUIRED: 1. Pneumatic applicator gun with holding arrangement for sealant cans. 2. Vacuum cups for holding glasses. 3. Tensioner Belt for holding Rear Quarter Fixed glass.
RkJQdWJsaXNoZXIy MTIwNTUz