ELECTRICAL 49 ii. REMOVAL OF COMBI SWITCH 1. Disconnect battery negative terminal. 2. Remove steering nacelle. (Refer “Removal & Refitment of steering nacelle" from Steering Section.) 3. Remove steering wheel. (Refer “Removal & refitment of steering wheel" from Steering Section.) 4. Disconnect combi switch connection. 5. Remove the four combi switch clock spring screws and take out. 6. Remove combi switch block from steering column. TORQUE VALUE TABLE Component Tightening torque value Combination switch Clamp screw 3 to 5 Nm Clock spring 1.2 Nm Light Stalk 3 to 5 Nm Wiper Stalk 1.2 Nm REFITMENT 1. Refit combination switch block properly on steering column. 2. Refit combination switch block mtg. Clip. 3. Reconnect combination switch connection. 4. Refit steering wheel. 5. Refit Steering nacelle. 6. Refit Battery negative terminal. COMBI STALK REPLACEMENT PROCEDURE 1. Remove the combi switch from vehicle. Refer removal & refitment of steering nacelle from steering section. 2. Disconnect combi switch connection. 3. Remove the two mounting screw of the stalks as shown below 4. Remove the stalk. INSTALLATION 1. Fit the new stalk 2. Tight the mounting screw of stalk 3. Fit the combi switch Torque value Table Component Tightening torque value Light / Wiper Stalk tightening torque in Daesung make combi Switch 0.3 to 0.4 Nm Clock spring 6 to 8 kgf-cm
RkJQdWJsaXNoZXIy MTIwNTUz