SUSPENSION 30 20. Using clamp (1) part No. 2779 5890 3303 puller (2) part No. 2654 5890 3508 and rest pad (3) part No. 2702 5890 2612 remove inner race of bearing from the hub. 21. Remove circlip from knuckle. 22. Pull out knuckle bearing using puller part No. 2779 5890 3302. INSTALLATION: 1. Follow the above steps in reverse order in appropriate sequence for its assembly. NOTE: If the disc surface is uneven showing rough marks, grooves machine it to the specified limit; measure the run out on dia 220 w.r.t. hub and disc resting face. Punch mark around bolt hole where run out on dia 220 is at low point. Align low point on disc and high point on hub while assembly. Assemble with countersunk screws. 2. Tighten drive shaft nut 23 to 26 kg-m torque and lock by staking. 3. Ensure that oil seal in transaxle is not damaged while fitting drive shaft. PRECAUTION: Use a new hub bearing after dismantled. In no case old bearing to be reused. No oil or lubricant to be used while pressing the bearing in the knuckle.
RkJQdWJsaXNoZXIy MTIwNTUz