SUSPENSION 27 17.Separate Hub Assy with bearing (Gen-3) from Knuckle by removing 4 bolts. GEN-3 BEARING INSTALLATION PROCEDURE: Ensure Gen-3 Bearing Mounting Procedure As Below A. It requires specific care for bolt tightening sequence and torque value. B. Sequences of bolt tightening of inner flange into the knuckle normally carried out as described in view. C. Apply thread locker to all bolts. 2-3 kg.m tightening torque value (pre tension) is applied to bolts is sequence of 1-3-2-4. D. Final tightening torque value must be then applied with same sequence. E. Bolt tightening sequence must be followed to avoid abnormal Residual Face Deformation Of Gen-3 Bearing. NOTE: Apply adhesive thread locker HS TS: 25408 on bearing mounting allen screws (thread locker code no: 56506 002562) before fitment. 1. Assemble the parts in revers sequence for assembly. 2. Tighten drive shaft nut 24.5 ± 1.5 kg-m torque and lock by staking. 3. Ensure that oil seal in transaxle is not damaged while fitting drive shaft.
RkJQdWJsaXNoZXIy MTIwNTUz