62 ENGINE2.2LDICOR Fig. 142 Fig. 143 Fig. 144 Fig. 145 AssemblyofCylinderHeadonCylinderBlock l Based on the piston projection / protrusion values above crank case, select correct thickness of cylinder head gasket. Refer the table (Fig. 142) l Install cylinder head on cylinder block, by locating the dowels properly (Fig. 143) l Tighten the cylinder head mounting screw's (Fig. 144) to specified torque in the proper sequence as shown below (Fig. 145) Cylinder headmounting bolt tightening sequence: Pistion projection gasket thickness Identification (mm) (mm) 0.56 to 0.64 1.3 1 Notch 0.65 to 0.73 1.4 2 Notches 0.74 to 0.82 1.5 3 Notches
RkJQdWJsaXNoZXIy MTIwNTUz