30 BODY 10. REMOVAL/INSTALLATION OF WINDOW GLASS (Fig. 13) REMOVAL l Remove the inner trim l Pull out required portion of plastic membrane. l Disconnect windowwindingmotor connector from wiring harness. l Lower window glass by connecting 12V battery to motor. l Remove 2 mounting screws & nuts and lift up the glass carefully. INSTALLATION l Insert the door glass in the window slot properly. l Align mounting holes of door glass and regulator. Fit 2 screws (M6x10) and tighten the screws with nuts. l Roll up and down the glass and ensure that glass is moving without binding. Ensure that there is no gap between glass and glass run mould, when the glass is lifted up. Use 12V battery for rolling up and down the glass. l Connect windowwindingmotor connector towiring harness. l Apply sealant (Butyl mastic) on the door inner panel and fix plastic membrane on it. l Fit the inner trim. Fig. 13. 1. WINDOWGLASSMOUNTING SCREWS 1
RkJQdWJsaXNoZXIy MTIwNTUz