51 ELECTRICALS c) Disconnect electrical connectors of master cum follower for driver side door. d) Disconnect bell crank lever link for front door (inner lock link for rear door) from latch after unlocking plastic clip. Disconnect solenoid link of master cum follower from door latch after unlocking the plastic clip. e) Loosen mounting nuts and remove master cum follower unit with mounting plate. Note the type of master cum follower. f) Follow the above procedure (‘a’ to ‘e’) for removal of follower unit from co-driver side door, rear LH door and rear RH door. Note the type of follower unit. g) Follow the above procedure (‘b’ to ‘d’) for removal of follower unit from tail gate. Loosen mounting screws and remove the follower unit from tail gate. Inspection l Check proper operation of door handle, lever, inner handle and door lock. Rectify for any defect. l Check the proper functioning of the replaced master cum follower unit / follower unit on the ring. Hold the output lever lightly to check that unit is exerting force. If not, replace with the working unit. Installation of Master cum follower unit/ follower unit a) For fitment of new master cum follower unit on driver side door remove the mounting plate from old master cum follower unit and fit on newmaster cum follower unit. (New master cum follower unit and old one should be same type) b) Fit master cum follower unit along with mounting plate on the door. c) Assemble the solenoid link from master cum follower to door latch. While fitment ensure that knob and master cum follower lever is in same mode i.e., both are in unlock position or in lock position. Lock the connecting link in position by plastic clip. d) Assemble the bell crank lever link for front door (inner lock link for rear door) to door latch. Lock the connecting link in position by plastic clip. e) Connect electrical connectors of the master cum follower to wiring harness. f) Follow the above procedure (‘a’ to ‘e’) for installation of follower units on the co-driver side door, rear RH door and rear LH door. g) Do not disturb the adjustment of door handle link and door lock link. If disturbed readjust and ensure proper functioning of door handle and door lock. h) Check and ensure proper functioning of the central locking system. i) Fix plastic membrane, door inner trim. Refer body group. j) Check proper functioning of window winding.
RkJQdWJsaXNoZXIy MTIwNTUz