39 ELECTRICALS 16. ANTITHEFT DEVICE : Immobiliser (If fitted) Immobiliser (Anti-theft security system) if fitted : This system disables the starter motor circuit, ignition supply and fuel cut-off solenoid supply and fuel cutoff solenoid supply. The vehicle can be started only if the key fitted with corresponding transponder is inserted in the ignition switch. A. Programming the keys of the vehicle equipped with transponder : 1. Insert a key with transponder in the ignition switch and turn to “ON” (+15) and then to OFF. 2. Take away the key from the ignition switch : the LED starts flashing fast for 30 seconds, during this time move the transponder master card close to the ignition switch Fig. 42 (where) the antenna is located) and wait until the LED goes off. 3. Move the transponder master card away: the LED starts flashing very fast for 30 seconds, during this time the system is set for the 1st transponder self-learning. 4. Insert the 1st transponder key in the ignition swi tch : LED wi l l go off; the 1st key is programmed. 5. Take away the programmed key from the ignition switch : the LED starts again to flash very fast for another 30 seconds, during this time. 6. Insert the 2nd transponder key in the ignition switch : the LED will go off; the 2nd key is programmed. Take away the key from the ignition switch. 7. If the vehicle is equipped with only 2 keys, wait for 30 seconds, : the LED will go off and then start to flash slowly. The programming cycle is finished. 8. If the vehicle is equipped with a 3rd transponder key, don’t wait for 30 seconds, and insert the 3rd key in the ignition switch : the LED will go off and start to flash slowly. Take away the 3rd key from the ignition switch. The programming cycle is finished. Fig. 42 - The operations have to be made in the right time; otherwise the function will finish. - In case of mistakes, repeat the programming procedure from the very beginning. B. Disabling/Enabling the immobilizer in the event of breaking or loosing the keys with transponder : 1. Insert a key without transponder in the ignition switch and turn to “ON” : the LED goes off. Move the transponder master card close to the ignition switch: the LED remains switched off. The immobilizer is disabled. Move the transponder master card away : the vehicle normally runs. 2. The immobilizer is automatically ENABLE after 30 seconds turning the key to OFF. 3. To switch on the vehicle again, using the key without transponder, proceed as indicated at point B1.
RkJQdWJsaXNoZXIy MTIwNTUz