Repair Guideline Tester-Display No. Work Instructions Set Value Fault Codes Connection Troubleshooting : Set Value : Causation : 43 ABS REPAIR GUIDELINES 13 RR Speed Sensor Ignition on more than C1210 RR sensor(pin3) Range/Performan- With vehicle jacked up, 40 km/h (26 m/h) Ground RR(pin1) ce Plausibility fault slowly turn RR wheel by hand OR OR diagnostic-tester drive vehicle display approach- ing speedometer display Important Notes: • Ignition OFF before the plug connector will divided from the wheel- speed sensor. • Couple the diagnostic tester, Ignition on • ABS and brake • Speed Wheel Sensor or lines interrupted warning lamp (temporary or static) illuminate • Read the DTC. • Impulse Wheel fault • Check the wheel-speed and • Wheel- speed by • Intermittent contact between wheel- correlation of the wheel to the sensors wheel RR speed sensor to cable harness(connector) • Check wheel-speed signal of the • Wheel- speed must • Air gap between sensor and impulse correct min value be always existent. wheel. • Wheel speed more than 2 km/h(under test-bench wheel speed the same as the rollers)
RkJQdWJsaXNoZXIy MTIwNTUz