26 TRANSFER CASE Breather, Input Shaft and Carrier Refer fig. 25&26 Place the planet carrier assembly on a work bench such that the retaining ring’s mounting groove faces upward. Install the sun gear with the hub end up into the planet carrier assembly. Rotate the sun gear to make sure that gears are fully meshed. Align the tabs and install the thrust plate into the planet carrier assembly. Install the retaining ring to the planet carrier assembly. Press the needle bearing and then the new sleeve bearing into the input shaft assembly. Fig. 26 Install the planet carrier assembly onto the input shaft and install the thrust washer. Press the bearing over input shaft. 72. STUD 73. BOLT 74. ADAPTER ASSY 75. SNAP RING 76. OIL SEAL 77. SPIROL PIN 78. FRONT ADAPTER 79. RETAINING RING 80. BEARING 81. INPUT SHAFT ASSY 82. SLEEVE BEARING 83. NEEDLE BEARING 84. INPUT SHAFT 85. THRUST WASHER 86. GEAR CARRIER ASSY 87. RETAINING RING 88. THRUST PALET 89. SUN GEAR 90. PLANET CARRIER ASSY 98. BREATHER 111. TRANSFER CASE 82. SLEEVE BEARING 83. NEEDLE BEARING 84. INPUT SHAFT Fig. 25 Fig. 26
RkJQdWJsaXNoZXIy MTIwNTUz