21 TRANSFER CASE Adapter Input And Carrier Gear Fig. 14 Remove the breather. Remove the six bolts. Remove the adapter by separating the adapter sealer bond (Pry front adapter, take care not to damage the adapter or the case.) Remove the adapter assembly, input shaft assembly and carrier gear assembly. Remove snap ring, and oil seal from front adapter. After removing snap ring, pull out the bearing and thrust washer form input shaft assembly and separate the input shaft assembly from carrier group assembly. Remove the needle bearing and sleeve bearing from input shaft assembly. Remove the retainer ring, thrust plate and sun gear from the planet carrier assembly. Do not disassemble the planet carrier assembly. 72. STUD 73. BOLT 74. ADAPTER ASSY 75. SNAP RING 76. OIL SEAL 77. SPIROL PIN 78. FRONT ADAPTER 79. RETAINING RING 80. BEARING 81. INPUT SHAFT ASSY 82. SLEEVE BEARING 83. NEEDLE BEARING 84. INPUT SHAFT 85. THRUST WASHER 86. GEAR CARRIER ASSY 87. RETAINING RING 88. THRUST PLATE 89. SUN GEAR 90. PLANET CARRIER ASSY 98. BREATHER 111. TRANSFER CASE Fig. 14
RkJQdWJsaXNoZXIy MTIwNTUz