50 GEAR BOX G-76 Slide shifter shaft - Rev. speed (94) in the housing bore. Fig. 98 Locate selector & shifter finger (93) between shifter dog - 3rd/4th notch and reverse speed shifter shaft under cut. Insert selector shaft from bottom through selector lever (108) aligning rollers with its splines. Then pass it through selector & shifter finger and ensure that notch at end is facing towards detent (89). (To be fitted afterwards). Fig. 99 Align hole of selector shaft and selector & shifter finger. Fit spiral pin (124). Fig. 100 Locating swing lever (95) between under cut of reverse shifter shaft and shifter shaft Reverse/5th. Ensure that notch on the lever is at the top and towards reverse shifter shaft. Fig. 101 Fit circlip (97) to pin (96), if removed earlier. Insert pin through bearing block and swing lever. Fig. 101 Fig. 100 Fig. 99 Fig. 98
RkJQdWJsaXNoZXIy MTIwNTUz