105 4 DLT ENGINE Installation of accelerator cable 1. Insert accelerator cable pedal end inside the firewall hole. 2. Insert inner cable end in accelerator pedal. Refer fig. 194 & 195 RHD/LHD pedal end. 3. Locate accelerator cable in clamp on firewall as shown in the Fig. 194 & 195 and route the cable. 4. Loosen the nut from the threaded end of the cable. Engage the threaded end of the cable in throttle body bracket. Insert inner cable end socket in the FIP lever ball pin Fig. 196. Lock the socket with spring pin No. 14, lock the ball pin No. 11 with lock plate No. 12. 5. Adjust the dimensions 67 + 3 mm for RHD and 42 + 2 mm for LHD. Ensure tightness in inner cable by adjusting the nuts on threaded end of the cable. 6. Ensure that when accelerator pedal is fully depressed, full travel of throttle lever is achieved. Removal of Accelerator cable Removal of accelerator cable is in reverse order of installation. Fig. 194 Fig. 195 mm mm Fig. 196 LHD RHD Inner Cable Fire wall Accelerator pedal Inner Cable
RkJQdWJsaXNoZXIy MTIwNTUz