FUEL SYSTEM 4 Fig. 3b Fig.3c Fuel level gauge Fuel strainer Fig. 3d FUEL STRAINER SUCTION LINE PURGING OF FUEL TANK Procedure 1. Remove fuel tank from the vehicle 'Refer procedure as mentioned above. 2. Remove fuel strainer and fuel level gauge from fuel tank. 3. Shift the tank to flushing area. 4. Fill tank with warm water or normal tap water and agitate vigorously and drain water. Repeat the procedure until inside of tank is clean. 5. Replace the fuel tank if it is rusty from inside. 6. Completely flush out remaining water after washing. Warning : Do not allow water to remain inside fuel tank after washing. This will cause corrosion inside fuel tank. Assembly 1. Assemble fuel strainer and fuel level gauge to fuel tank. Assemble fuel strainer with new 'O' ring. Connect suction line to fuel tank strainer and tighten banjo bolt to specified torque Always use new sealing washers. 2. Connect return line to fuel tank by simply pushing Q.C. 3. Install fuel filler hose after fuel tank has been mounted in place. Failure to follow this caution could result in leakage from around hose connections. 4. Fill the tank with fuel.
RkJQdWJsaXNoZXIy MTIwNTUz