PROPELLER SHAFT 12 Fig. 25 Fig. 26 Fig. 27 Fig. 24 Move one end of the cross to cause a trunnion to project through the cross hole beyond the outer machined face of the yoke lug. Place a bearing assembly over the trunnion diameter and align it to the cross hole. Using an arbor press, hold the trunnion in alignment with the cross hole and place a solid plug on the upper bearing assembly. Press the bearing assembly into the cross hole enough to install a snap ring. Fig.24 Install a snap ring. Fig.25 Repeat the above two steps to install the opposite bearing assembly. Fig.26 If the joint is stiff, strike the yoke ears with a soft hammer to seat the needle bearings. Fig.27 Caution : Be sure that snap rings are properly seated in grooves. Repeat the above steps at the opposite end of the drive shaft in installing a second kit. If removed earlier, the unitized seal should be replaced with a new unit. Install a new seal by generously lubricating the seal lip and press it over slip yoke using a small arbor press.
RkJQdWJsaXNoZXIy MTIwNTUz