ENGINE 78 INSTALLATION OF CYLINDER HEAD COVER 1. Place the cylinder head cover gasket on the cylinder head. 2. Place the cylinder head cover on the gasket. 3. Insert the studs through the holes of the cylinder head cover and hand tight the studs in the tapping on cylinder head. 4. Tighten the studs fully with a ratchet tubular spanner. 5. Insert the rubber isolators in the studs on the cylinder head cover. 6. Hand tight the dome nuts on the studs. 7. Apply the specified torque to the dome nuts. 8. Fit the air intake elbow with the gasket with the 2 bolts and apply the specified torque. 9. Fit the EGR vale with the gasket on the air intake elbow and EGR tube. Tighten the screws on the air intake elbow. 10. Insert the rubber hose in the air intake elbow and the other end in the pipe. 11. Tighten the hose clamps. 12. Fit the cover under the wiper motor and tighten the bolts. 13. Fit the wiper motor subassembly along with the linkages. 14. Fit the wiper motor plastic cover. 15. Fit the bonnet.
RkJQdWJsaXNoZXIy MTIwNTUz