ENGINE 74 Fig. 8 8. Before tightening rocker shaft bracket bolts, see that the ball pins are loosened to prevent undue pressure on push rods and that rocker shaft mounting bolts with the threaded holes in heads are fitted in correct positions for cylinder head covering mounting (fig. 8). 9. Adjust valve clearance as per specified procedure and to the specified values. 10. Install cylinder head cover with the cylinder head cover gasket as per specified procedure. 11. Install the upper water cooling line with new gaskets. Connect the radiator hoses and thermostat as per procedure. 12. Install the rail, Injectors with new copper washers, Injector Claw and new set of HP lines as per the specified procedure. 13. Fit new leak-off pipes on the Injectors. 14. Insert all the electrical connections to the Injectors, rail, water temperature sensor and T-map sensor. 15. Assemble the power steering subassembly on the cylinder head and tighten the belt tension. 16. Fit the exhaust manifold gasket, exhaust manifold, turbocharger with gasket, exhaust down pipe. 17. Install the EGR valve, EGR tube and vacuum connections as per procedure. 18. Connect the exhaust system to the exhaust down pipe. 19. Install the Air Intake Elbow with the gasket on the cylinder head cover. 20. Install the air intake system on the vehicle and tighten the hose clips. 21. Fill coolant in the cooling system.
RkJQdWJsaXNoZXIy MTIwNTUz