ENGINE 65 Fig. 1 Sedimenter location Fig. 2 Sedimenter mounting bracket Service Water drain operation to be done on both filter and sedimenter 1. Each time when water is detected by sedimenter water sensor. 2. Each vehicle service. Procedure for draining water from Sedimenter 1. Stop the engine, and wait until pressures stabilize. 2. Unclip one of the hydraulic connections (either inlet or outlet) and the electric connector of the water sensor. 3. Place a container underneath the water sedimenter. 4. Unscrew the water sensor about 2 turns. 5. Wait until all the water has drained out of the water sedimenter. 6. As soon as the flow is free of water, screw the water sensor to the required torque. 7. Clip the hydraulic connector and the electric connector to the water sensor. 8. Use hand primer pump to refill the line before restarting. NEW SEDIMENTER LOCATION : The sedimenter is located near fuel tank on side long member of the chassis. New Removal And Fitment Procedure Of Sedimenter: Removal : 1. Disconnect the water sensor electrical Connection 2. Remove the Quick fit connector from sedimenter to tank 3. Plug the pipe and port with the appropriate caps after pipes are removed. 4. Remove the M8 bolt of the sedimenter mounting bracket. 5. Take out the Sedimenter. Fitment : 1. Place the sedimenter in the bracket with the protective cap 2. Tighten the sedimenter in the bracket. Remove the protecting caps and fix the inlet and outlet ports by identifying the arrows shown on the sedimenter. 3. Clip the electrical connector to the water sensor. 4. Check that there is no leakage after assembly
RkJQdWJsaXNoZXIy MTIwNTUz