ENGINE 49 Fig. 13 Fig. 14 Fig. 15 12 Fit new oil seal on cover using drift, 312 589 12 39. Fig. 13. It is advisable to apply sealing compound on outer diameter of seal before assembly. 13 Examine the spacer (for oil seal) on the crankshaft for wear and replace if necessary. 14 Stick new gasket to the cover by using sealing compound. 15 Apply grease on the oil seal lip and fit cover carefully without damaging the oil seal lip Keep lock plate for alternator mounting bolt in position. Tighten the cover screws to specified torque. 16 Install crankshaft pulley and thrust washer. Tighten mounting bolt to specified torque. Fig. 14. Unlock the Crankshaft at the fly wheel. 17 Fit the noise dampening cover on the timimg gear cover. 18 Install pulley on hub. Insert lock washers over mounting bolts and tighten bolts to 3.5 mkg torque 19 Mount poly V-belt and adjust tension (belt deflection under thumb pressure = 20 mm) Fig. 15. 20 Install radiator and fill in cooling water. If fresh water is used add anti-corrosive/anti-freeze agent. 21 Check engine for oil/water leaks after test run and rectify, if any.
RkJQdWJsaXNoZXIy MTIwNTUz