53 GEAR BOX G-76 Align retainer plate in Reverse Idler gear collar, simultaneously locating its pin in housing. Tighten hex screw along with spring washer in the housing. Ref fig. 118 Fig. 118 Fig. 119 Fit linear bearing in the housing - Front, if removed earlier. Place drive shaft. Ref fig. 119 Apply shellac and put gasket over housing parting surface. Place gear box housing - Front over the rear half aligning dowel pins and gently tap it with mallet. Put hex nuts along with plain and spring washer. Tighten all nuts evenly. Ref Fig. 120 Fig. 120
RkJQdWJsaXNoZXIy MTIwNTUz