ELECTRICAL 153 ELECTRICAL Two stage Unlocking: When Vehicle is central locked following can unlock all doors. Turning the key in the driver's or passenger’s door lock cylinder once to the unlock position Pulling the lock switch/ knob to the unlock position NOTE: The lock switch/knobs and mechanical key actions drive “the same” latch actuations Remote unlock: 1. Pressing the unlock button on the remote control once will Unlock the driver door and fuel filler flap only 2. Pressing the unlock button again on the remote control will Unlock remaining doors Reverse cycling: Lock by Remote: When lock is requested by remote key and driver door is open then all door motors are driven to lock and then driver door motor is driven back to unlock only. When lock is requested by remote key and any other door is open then all door motors are driven to lock and driven back to unlock. Lock by driver/co-driver door (with internal lock/unlock switch) key or internal switch/knob: When lock is requested by mechanical key in driver/co-driver lock or internal door locking knob/ switch and if any door is open then all door motors are driven to lock and then driven back to unlock. Lock by interior door locking knob/ switch from rear passenger doors (without internal lock/ unlock switch):- Only the individual door will lock mechanically and stay locked (i.e. no central locking takes place) – there is no reverse cycling because there is no lock/ unlock switch that the BCM can detect. NOTE: When a reverse cycle condition occurs by remote, the mislock warning is sounded to alert the customer that locking was unsuccessful. No flasher feedback is given. Auto-Locking on Drive Away: When vehicle is unlocked then it will be automatically central locked when all doors are closed, ignition is turned ON and the vehicle speed goes above 12 Kmph. The doors will be relocked after any door has been opened, when the doors become closed again and vehicle speed goes above 12 Kmph. NOTE: If the vehicle speed signal is missing, the auto lock feature will be disabled. If diagnostics is monitoring the crash input line and there is problem with this circuit, the auto lock feature will automatically be disabled. The airbag / restraints warning light should flash to alert an issue with the crash input line. Crash Unlocking: The vehicle is fitted with an inertia switch. On a crash event, the switch is activated then the BCM will unlock all the doors. The crash input should be scanned for every 100ms. The system will unlock all doors automatically when an impact to the vehicle occurs and ignition is ON .If the vehicle is locked and the crash input senses the crash signal (i.e. inertia switch activation) the vehicle will initiate the unlock process within 100ms. In the event of the inertia switch being activated, the hazard lamps and indicators, all three roof lamps will switch on. They can only be switched off when the vehicle user de-activates the inertia switch. During crash unlock activated the drive away locking is disabled. Auto Relocking: After the vehicle has been central locked by remote and if a remote unlock is requested, the required door(s) unlock. After this unlock action, if no door ajar input is detected (i.e. no door is opened) or if no ignition transition to Run/ Start is detected, then the doors relock after 45 seconds.
RkJQdWJsaXNoZXIy MTIwNTUz