ELECTRICAL 106 REMOVAL: 1.Disconnect the wiring harness connector. 2.Remove the pigtail clips from the bracket. 3.Loosen mounting nut and remove the reverse light switch from taped hole and take out the reverse light switch. INSPECTION: Test the switch with a Multimeter. Clip the probe of the multimeter to switch terminal and check the continuity. CONDITION SPECIFIED Not Pushed(OFF) (Reverse gear not applied) No Continuity Pushed(ON) (Reverse gear applied) continuity If not as per specified condition, then replace the switch. FITMENT: 1.Align the reverse light switch to hole provided on the gear box and tighten it. Tightening torque – 4 ± 0.5 Kgm. 2.Fix the wiring harness by inserting the pigtail clip into the bracket. 3.Connect the wiring harness.
RkJQdWJsaXNoZXIy MTIwNTUz