ELECTRICAL 77 ELECTRICAL REFITMENT 1.Pull out the washer hose from the cutout and connect to the washer nozzle. 2.Snap fit the nozzle into the cutout. 8.9.4.4 REAR WASHER NOZZLE LOCATION: It is fitted on the Centre high mounted stop lamp. REMOVAL 1.Remove the tail gate upper trim. 2.Remove the Centre high mounted stop lamp (Refer Centre high mounted stop lamp removal procedure) 3.Disconnect the washer hose from the rear nozzle. 4.Pry out the nozzle from out side the Centre high mounted stop lamp. NOZZLE SETTING: 1.Check the water jet spot on the tailgate glass if it is on glass as shown in the below fig then OK. 2. If spot of the jet is not proper then adjust the nozzle angle manually such that both the jets should fall on tailgate glass. REFITMENT: 1.Insert the nozzle into the cutout provided on the Centre high mounted stop lamp. 2.Connect the washer hose from inside of Centre high mounted stop lamp to nozzle. 3.Fit the Centre high mounted stop lamp. 4.Snap fit the tail gate upper trim. NOTE: Rear nozzle should be fitted properly in the cutout and there should not be any lateral movement. Check that there is no damage in the lock area and no missing lock in the rear nozzle. NOZZLE CLEANING: 1. Remove the 3rd row roof lam. 2.Remove wash pipe joint (Access it from 3rd roof lamp area). 3.Blow high pressure air through the pipe NOTE: If specified solution not used for washer bottle there is possibility of nozzle blockage.
RkJQdWJsaXNoZXIy MTIwNTUz