ELECTRICAL 34 and slide the brush plate on to the tool. Pull the tool with the brush plate off the armature shaft. 6.Pullout the armature from the stator frame. 7.Mark the relative positions of the drive end housing, the ring gear plate and the ring gear cover plate (parts of epicycloid gear train) with respect to each other using a marker. 8.Pullout rubber seal. Pullout bearing pedestal. Remove epicycloid gear with overrunning clutch and fork lever from drive end bearing housing. 9.Using mounting sleev 03-KDAL 5028 and a light hammer, knock back the stop ring. Using suitable pliers, bend the ends of the retainer wide apart. Remove retainer. Remove drive pinion from the drive shaft. 10. Using an Arbor Press, press out sintered bush from drive end bearing housing using tool HS/KDEP 1132/0/1 and replace with a new one using the same tool. 11.Using an Arbor Press, press out bush from commutator end shield using tool H-S/KDEP 1132/0/1 and replace with a new one using the same tool.
RkJQdWJsaXNoZXIy MTIwNTUz