PROPELLER SHAFT 11 PROPELLER SHAFT FRONT PROPELLER SHAFT REMOVAL 1. Remove the Stone guard rear piece. (For stone guard removal procedure refer Body section) 2. Loosen and remove the mounting bolts of bearing straps on the front axle side. 3. Properly support the propeller shaft. 4. Loosen and remove the mounting bolts for bearing strap on the transfer case side. 5. Carefully separate the propeller shaft from the vehicle. FITMENT For fitment follow the reverse procedure of removal. NOTE Follow all the precautions and safety instructions mentioned under rear propeller shaft (4X4) fitment. C TVD (TORSIONAL VIBRATION DAMPERS) LOCATION TVD is used to reduce the torsional vibration and it is located between propeller shaft and rear axle differential flange. REMOVAL 1. Hoist the vehicle on two a poster lift. 2. Lift the vehicle 3. Loosen and remove four nuts and disconnect the rear end of the propeller shaft from rear axle end. 4. Take out the TVD. FITMENT For fitment follow the reverse procedure of removal.
RkJQdWJsaXNoZXIy MTIwNTUz