PROPELLER SHAFT 9 PROPELLER SHAFT A. PROPELLER SHAFT (4X2) REAR PROPELLER SHAFT REMOVAL 1. Loosen and remove the mounting nut (4 Nos.) of flange yoke from rear axle. Take out the rear end of propeller shaft from rear axle along with vibration damper. 2. Pull out the propeller shaft from the slip joint at the centre bearing. FITMENT For fitment follow the reverse procedure of removal. FRONT PROPELLER SHAFT REMOVAL 1. Remove rear propeller shaft. 2. Remove the Stone guard rear piece from bottom side for easy access. (For stone guard removal procedure refer Body section) 3. Loosen and remove the bearing strap bracket retaining bolts at centre bearing joint from cross member. 4. Loosen and remove the mounting nut (4 nos) (1) of flange yoke from the gear box end and take out the front end of propeller shaft. 5. Carefully remove the propeller shaft along with centre bearing, bracket and rubber cushion. FITMENT For fitment follow the reverse procedure of removal. NOTE Discard the Nyloc nut and use new at the time of assembly. Check the slip yoke assembly after fitment.
RkJQdWJsaXNoZXIy MTIwNTUz