Rear Axle 15 Shows ring and pinion etched with metric identification. Refer Table B. Example 2 In metric In inches No punched on removed pinion + 5 m -3 No punch on new pinion +5m +4 Value derived from table -0.1 -0.007 Thickness of shims in OE assembly x y Thickness of shims in selected for new ring/pinion X -0.1 Y -0. 007 This dimension for front live axle will be different. On the bottom face of pinion, a number is etched. It can be a plus (+) number, a minus (-) number or Zero (0). Required pinion shim selection is achieved with help of this number. If alphabet "m" appears on pinion face shim, selection has to be done in mm (Metric). If alphabet "m" does not appear on pinion face, shim selection has to be done in inches (English). Shims with different thicknesses are available for selection. Use tables on next page as a guide for selecting correct thickness of shims either for addition or for subtraction from old shim pack. Note: Please observe the marking on pinion. If ‘m’ is found etched on the face, refer table B. If not refer table A TABLE A Old Pinion Marking (English) New Pinion Marking(English) -4 -3 -2 -1 0 +1 +2 +3 +4 +4 +0.008 +0.007 +0.006 +0.005 +0.004 +0.003 +0.002 +0.001 0 +3 +0.007 +0.006 +0.005 +0.004 +0.003 +0.002 +0.001 0 -0.001 +2 +0.006 +0.005 +0.004 +0.003 +0.002 +0.001 0 -0.001 -0.002 +1 +0.005 +0.004 +0.003 +0.002 +0.001 0 -0.001 -0.002 -0.003 0 +0.004 +0.003 +0.002 +0.001 0 -0.001 -0.002 -0.003 -0.004 -1 +0.003 +0.002 +0.001 0 -0.001 -0.002 -0.003 -0.004 -0.005 -2 +0.002 +0.001 0 -0.001 -0.002 -0.003 -0.004 -0.005 -0.006 -3 +0.001 0 -0.001 -0.002 -0.003 -0.004 -0.005 -0.006 -0.007 -4 0 -0.001 -0.002 -0.003 -0.004 -0.005 -0.006 -0.007 -0.008
RkJQdWJsaXNoZXIy MTIwNTUz