FRONT AXLE (4X4) 16 12.Disconnect upper wishbone ball joint. (For procedure refer suspension upper wishbone ball joint removal section) !! WARNING When the knuckle is disconnected from the upper wishbone the knuckle may fall outwards towards the operator. Hence supporting it is very essential. If proper care is not taken it may cause injury. The upper wishbone might spring upwards when released from knuckle, hence special care should be taken. 13.Support the stub axle assembly from below. Disconnect lower wishbone ball joint using puller (Part No. 287058904601). (For procedure refer Suspension section.) 14.Pull out the stub axle to free it from driveshaft. Carefully support the driveshaft. 15.Pull out the drive shaft from the carrier section follow the same procedure at other end also.
RkJQdWJsaXNoZXIy MTIwNTUz