REAR SUSPENSION 33 REAR SUSPENSION INSPECTION 1. Check the condition of anti-roll bar for any bend. If required replace the same with new one. 2. Check the condition of rubber bush and ball joint if found damaged replace with new one. 3. Check for grease in the mounting bearing block. ASSEMBLY 1. Locate the bushes and place the ball joint assembly on the bracket and tighten the nyloc nut. Follow the same procedure for other end also. NOTE Tighten the nyloc nut such that the gap between the edge of link and the nyloc nut is 10± 2mm as show in the figure above. 2. Position the anti-roll bar and install the bearing block bracket on to the frame by tightening the flange head screws on both ends. NOTE Apply 2.5 gm of grease should be applied on the inside and cavities of bearing block before fitment of anti roll bar. The mounting screws to be tightened to the specified torque, refer tightening torque table 3. Lock the ball joint for rotation using Allen key (5mm) and connect the anti-roll bar to the ball joint assembly by tightening the nyloc nut. Follow the same procedure at the other end also.
RkJQdWJsaXNoZXIy MTIwNTUz