TRANSFER CASE 39 TANSFER CASE 3. Press the ball bearing into cover and install snap ring. 4. Install the clutch coil assembly inside the cover and tighten three nuts. NOTE Before assembly, check the clutch coil for its proper functioning by checking the resistance value. The coil resistance should be in the range of 2.84 Ω at 25º C. 5. Apply 1.6 mm bead of Loctite RTV598 to the transfer case-mounting surface. For installation of cover, align the cover with transfer case. Do not use excessive force. 6. Locate the speed sensor assembly on the cover and push the same for fitment. 7. Install the cover onto the case and tighten 13 self locking (1) and 2 hexagonal headed (2) bolts positioning identification tag 8. Insert the speedo assembly in to the rear cover and tighten the screw as shown below.
RkJQdWJsaXNoZXIy MTIwNTUz