GEAR BOX 64 NOTE • Stake the collar in undercut with suitable chisel to secure the nut. • See the condition of collar nut if required replace the same with new one. • For securing the main shaft nut; collar to be staked in he slot. 25.Apply adhesive gasket eliminator over top cover face and fit it over the rear cover and put the hexagonal flanged nuts and tighten the same. NOTE New gasket should be fitted in between the mating surface of top cover and rear cover at the time of assembly. 26.Align the shifter linkage assembly properly with the shifting yoke and then slide the cylindrical pin and press the retainer clip to lock the shifter link along with the extension arm on to the gear box. NOTE • Apply grease on the spherical seat of shifter shaft end. • Check the condition of bush in the shifting yoke. 27.Slide the pin (1), place the spring washer (2) and press the retainer clip (3) to lock the extension arm on to the gear box. 28.Fit the magnetic drain plug, breather assembly and reverse indicator switch. 29.Align the clutch housing. Place the spring and bright washer and tighten the clutch housing mounting bolts. 30.Fit the clutch release bearing and clutch release fork. (For procedure refer clutch section.)
RkJQdWJsaXNoZXIy MTIwNTUz