GEAR BOX 22 For 4X4 version Lock the end yoke assembly with other end of the special tool (Part No. 2894 5890 35 17), loosen and remove the end yoke nut by holding it with sprocket (Part No. 2698 5890 41 01) and then pull out the end yoke with the help of standard puller. NOTE Same tool has to used for 4X2 and 4X4 7. Remove the plug which is at the bottom side of rear cover assembly. (For 4X2 Version only) NOTE If the plug is not removed, it is not possible to remove the 5th/ Reverse selector head from the shifter shaft because the spiral pin has no space for its removal. 8. Push out the spiral pins of (6x24) from the shifter shafts and free the shifter heads from their respective shafts. 9. Loosen and remove nuts (13 Nos.) connecting rear cover to rear housing and take out the rear cover along with the selector heads. (For 4X2 Version only) NOTE For 4X4 Version Loosen and remove outer nuts (1) (12Nos.) and inside nuts (2) (06 Nos.) on connection adaptor housing to the rear half and take out the adaptor along with selector heads. NOTE Remove oil seal in case of 4X4
RkJQdWJsaXNoZXIy MTIwNTUz