GEAR BOX 12 4.2.2.3 ON VEHICLE PROCEDURES A. GEARBOX REMOVAL 1. Drain the GB oil. 2. Remove the Transfer case (For Procedure refers transfer case removal in Transfer case section). In case of 4X2 vehicle remove the propeller shaft (For procedure refer Propeller shaft removal in Propeller Shaft section). 3. Remove the Gear shifter knob and bellow. (For procedure refer Body section). 4. Disconnect the reverse light switch connection. 5. Remove the vehicle speed sensor. 6. Disconnect the crank angle sensor connection. 7. Remove starter motor ((For procedure refers Starter motor removal procedure in Electrical Section). 8. Disconnect the earthing cable. 9. Drain clutch fluid from system. 10.Remove high pressure pipe (HPP) from bleeder adaptor. NOTE : Precaution to be taken to avoid dust/dirt entry in open ports of HPP and bleeder adaptor. 11.Support the Clutch housing and gearbox mounting cross member from below. 12. Loosen and remove the clutch housing mounting bolts on Engine. 13. Disconnect the wiring clips on the gearbox mounting cross member.
RkJQdWJsaXNoZXIy MTIwNTUz