CLUTCH 15 7. Keeping the clutch pedal pressed open the bleeding valve (turn anti-clockwise) until the fluid containing air escapes. NOTE Observe weather air bubbles are coming in the container and let the fluid flow into the container. 8. After few seconds close the bleeding valve (turn clockwise). 9. Release the clutch pedal slowly without jerk and hold it at released position for minimum 2 seconds. 10.Repeat the steps 5 to 9 until fluid coming in the container is free from air bubbles. ! CAUTION Fluid drained from the system should be discarded. 11.After completion of bleeding operation ensure that bleeding valve is turned to off position. 12.Disconnect the bleeding pipe and reinstall the dust cap. C. CLUTCH FLUID DRAINING PROCEDURE 1. Remove the stone guard for access of bleeding valve (hydraulic adapter) from the vehicle. 2. Clean the external areas of the hydraulic adapter and remove the dust cap from the hydraulic adapter bleeding connection. 3. Connect the bleed pipe to the hydraulic adapter bleeding connection. 4. Place the other end of bleed pipe in a clean container which should be at a lower level than the slave cylinder and ensure that the pipe is submerged in the clutch fluid. NOTE After removing the hose, plug the passage of CMC and the hose with suitable caps to avoid entry of any contaminants. 5. Press and release the clutch pedal repeatedly until the fluid stops coming out of the bleeder valve. ! CAUTION Fluid drained from the system should be discarded. Care should be taken while actuating the plunger that it should not be actuated beyond its maximum extended length.
RkJQdWJsaXNoZXIy MTIwNTUz