ENGINE 167 PIN DETAILS PIN NO DESCRIPTION Pin 1 Power supply Pin 2 Signal Pin 3 Earth REMOVAL 1. Remove engine cover. 2. Disconnect the wiring harness connector from cam shaft position sensor. 3. Remove one mounting bolt of sensor and take out the cam position sensor from its location. INSPECTION 1. Using multimeter measure the voltage across the pins of cam sensor. 2. With ignition ‘ON” voltage between pin 2 & 3 is as below, • 4.7 V (When the flag is not in front of the sensor) • 0.6V (When the Flag is in front of the sensor) REFITMENT 1. Locate the cam shaft position sensor and fit one mounting bolt and tighten with specified torque. Tightening torque for bolt – 1 Kgfm 2. Connect the wiring harness connector to the cam shaft position sensor. 3. Fit engine cover.
RkJQdWJsaXNoZXIy MTIwNTUz