HVAC 15 HVAC 10.1.5.1 CONTROL PANEL 01 MODE SELECTION 02 PUSH BUTTON- RECIRCULATION 03 LIGHT INDICATOR 04 BLOWER SPEED 05 PUSH BUTTON AC/ ECO 06 TEMPRETURE SELECTION 07 PUSH BUTTON REAR DEFOGGER 08 PUSH BUTTON AC/REAR The HVAC control panel consists of 4 Push buttons and 3 rotary knobs that can be used to set the required temperature inside the cabin. In addition to this the control panel also acts as a control unit for the HVAC system in which all the software calibrations are embedded. 1. PUSH BUTTONS a. RECIRCULATION / FRESH AIR (AMBER LED) This is a push button that can be used to position the Air inlet door, either to allow fresh air to come inside the cabin or to recirculate the air within the cabin. b. NORMAL AC / ECONOMY AC This is used to choose Normal AC, Economy AC or to switch OFF the AC c. REAR DEFOG /ORVM DEFOG This is a push button used to switch ON the rear defog heater grids on the rear window, to enable the clearing/ defogging of the rear window. The rear defog switches OFF after a pre-determined time of approximately 15mins. 2. ROTARY KNOBS a. FAN SPEED SELECTION The Fan speed selector allows the user to select four blower speeds ± 1, 2, 3 and 4. An OFF position´ ´ is also provided to shut the system off. b. TEMPERATURE SELECTION The temperature selector knob can be used to select the required temperature varying from full cold (on the extreme anti-clockwise) and full hot (on the extreme clockwise). c. MODE SELECTION The mode knob is used to select the air delivery mode. There are 5 different modes as given below. Face Mode Face ± Leg Mode
RkJQdWJsaXNoZXIy MTIwNTUz