REAR SUSPENSION 13 V. PAN HARD ROD REMOVAL 1. Apply hand brake. 2. Loosen and remove the bolts & nuts connecting pan hard rod to the bracket on rear axle and bracket on chassis frame. 3. Tap the pan hard rod gently and take out the assembly. INSPECTION 1. Check the condition of rubber bushes. If required replace the bushes with new one. NOTE For replacement of bushes refer the procedure of bush removal and fitment in overhauling section. 2. Check the condition of lower link for any bend and damage. If required replace the same with new one. REFITMENT For refitment follow the reverse procedure of removal. Apply the specified torque as per the procedure given in “Rear suspension links tightening procedure”. VI. REAR SHOCK ABSORBER REMOVAL 1. Hoist the vehicle on two post lift. 2. Support the rear axle from below at both ends. 3. Disconnect the LH side upper link from the rear axle bracket by removing the mounting bolt to avoid any damage to the fuel tank assembly. 4. Loosen and remove the lower mounting nut of the rear shock absorber. 5. Loosen and remove two mounting bolts from the top.
RkJQdWJsaXNoZXIy MTIwNTUz