REAR SUSPENSION 11 2. Position the anti-roll bar and install the bearing block bracket on to the frame by tightening the flange head screws on both ends. NOTE Apply sufficient amount of silicon grease MOLICOTE 33 (Medium) on the anti-roll bar over bearing width before fitment of bearing block. The mounting screws to be tightened to the specified torque, refer tightening torque table 3. Connect the anti-roll bar to the ball joint assembly by tightening the nyloc nut. Follow the same procedure at the other end also. II. REAR SUSPENSION LINKS TIGHTENING PROCEDURE. NOTE This procedure is to be followed to tighten any of the rear suspension bushes. 1. Position the vehicle on a pit. Loosen the bolts and then re-tighten them in vehicle unladen condition. NOTE Before tightening to the specified torque confirm that, at vehicle unladen position the lower link is inclined at an angle of 3.40 (w.r.t. horizontal) or that chassis height (distance between the centre line of rear axle and chassis height at rear axle location) is 280±3mm. The above height or angle needs to be maintained if any link is removed.
RkJQdWJsaXNoZXIy MTIwNTUz