TRANSMISSION 57 Shift Linkage Adjustment Procedure. NOTE: The vehicle is supposed to be on hoist, transmission protections removed and transmission selector in Park position. 1. Loosen and remove the Hexagonal M8 screw of anchoring bracket. NOTE: Make sure Gear shifter lever which is fitted in driver cabin is in park mode by shifting lever towards front of vehicle. 2. Properly locate the fixture plate (Part No: 2870 5890 26 21) in removed hexagonal M8 screw of anchoring bracket hole and gear shift lever assembly with Across Flat area of pivot pin as shown below. Then again insert the M8 screw and give 2kgfm of tightening torque. 3. Release the torque of Hexagonal M12 thin nut of Pivot pin. WARNING: Do not bend the shift cable when opening the shift linkage adjustment nut. 4. Discard the lock washer. 5. Insure transmission selector and selector lever in Park position –P – (see illustration). 6. Install NEW lock washer. 7. Tighten the shift control linkage adjustment nut to tightening torque 40-45 Nm
RkJQdWJsaXNoZXIy MTIwNTUz