TRANSMISSION 54 8. Align & install the control valve body assembly on the main case helping by two centering holes. NOTE: When installing new Mechatronic, don’t forget to install Detent spring lever from previous Mechatronic with H10 wrench. Tighten to 12 Nm. 9. Install bolts (1 to 6) securing the control valve body assembly to the case assembly. 10. Tighten the bolts to 7-9 Nm according to following torque sequence as shown. Quantity: 6–M5X73. 11. Reinstall the electrical connector passage sleeve (1). Push the sleeve straight into the case bore & connector. Do NOT rotate the sleeve at any time. Ensure the sleeve is fully seated into the case. When the sleeve is properly installed, the distance from the case surface to the end of the sleeve should be 14–16mm. Push down the electrical connector slide lock (2). 12. Reinstall the oil filter and oil pan following the repair procedure 2 and 7. 13. Connect the vehicle harness. See Mechatronic Removing Procedure. 14. Program the transmission module. 15. Enter the VIN into the transmission module using the diagnostic tool. 16. Clear any fault codes generated by the programming / replacing operation. 17. Road test the vehicle and perform the transmission adaptation procedure.
RkJQdWJsaXNoZXIy MTIwNTUz