GEAR BOX 56 ASSEMBLY PROCEDURE 1. Before starting to assemble the gear box following preparation needs to be done. 2. Measure the dimension between counter shaft 3rd gear rear face and taper roller bearing outer race face. Consider this distance as “A”. 3. Measure the dimension between Main shaft 2nd gear shoulder face front and taper roller bearing outer race face. Consider this distance as “E”. 4. Place the rear half on the mounting plate (Part No. 2654 5890 2613) which is locked on the mounting stand. 5. Place shifter fork assembly 1st / 2nd and Reverse/5th over main shaft assembly at its proper place, keeping notches towards coupling flanges side. 6. Place shifter fork 3rd/4th alone without shaft at its place over main shaft sleeve such that its collar is facing outwards. 7. Keep counter shaft and reverse idler shaft assembly aligned with main shaft and properly place the assembly into the rear half. 8. Align the shifter shaft (3rd/4th) with the hole of the fork and then press the spiral pin. (6X28).
RkJQdWJsaXNoZXIy MTIwNTUz